UTStarcom UT-300R2, User Manual

Page: 28 / 85

26 Chapter 4 Web-based Management
3 Select the Encapsulation type (LLC or VcMux) radio
button that corresponds to the encapsulation in use by
your ISP
4 Enter the IP Address, Subnet Mask, and Default Gateway
address as supplied by your ISP.
5 When you are satisfied that all the WAN settings are
configured correctly, click on the
Apply button.
6 The new settings must be saved and the UT-300R2 must
be restarted for the settings to go into effect. To manually
save and reboot the UT-300R2, click on the
Tools
directory tab and then click the System menu button. On
the menu that appears, click he
Save & Restart
button.
The UT-300R2 will save the new settings and restart.
Upon restarting the UT-300R2 will automatically establish
the bridged WAN connection.
Note:
Some accounts use PPP connection software for their
Internet service connection. If you have been given a CD with
PPP connection software, install this now as instructed by your
service provider. After the UT-300R2 has rebooted it will
negotiate the ADSL connection. Use the connection software to
log on to the ISP network and access the Internet.
Configuring a PPP Connection for the WAN
Most ADSL accounts will use either the Point-to-Point Protocol
over Ethernet (PPPoE) or the Point-to-Point Protocol over ATM
(PPPoA) connection. Follow the instructions below to configure
the UT-300R2 to use a PPPoE or PPPoA for the Internet
connection. Make sure you have all the necessary information