Users guide for IP-SwitchBox902
1.
Overview
2.
Main page.
3.
Reset page.
4.
Telnet -RS232 page.
5.
Configuration pages.
5.1
Config main.
5.2
Switches.
5.3
User manager.
5.4
Access rights.
6.
The RS232 port.
6.1
Remote control via telnet.
6.2
Control via RS232.
6.3
Configuring via RS232.
7.
Many simultaneous users.
8.
Safety aspects.
9.
Control from user program.
10.
Default values.
11.
Technical specifications.
12.
Get started, fast!
1. Overview
IP-SwitchBox902 can switch 16 relays on or off.
Control is made with a web interface via ethernet
or with simple ASCII text commands via RS232.
It is also possible to control the RS232 port via
Telnet.
On the main page (index.htm) there are buttons for
switching on/off the outputs.
On the reset page (reset.htm) there are in addition
buttons to make a temporary switching off for a
specified time.
This time can be configured for each output.
At power on the outputs are switched on after a
delay. This delay can be configured for each
output, from 0s up to 600s.
In this way connected equipment can be started in
sequence after power failure.
The Box can have usernames/passwords for 8
users + admin + telnet.
Each user can have individual access rights for
each output. The rights can be read, write or no.
Admin always has full rights except for telnet.
It is also possible to configure read/write rights for
users without passwords.
You can add names above the buttons on the web
pages and at the top of the web pages.
The box can be reserved for one single user at a
time. When that user not has accessed the box
during the configured time any other user can
access it.
