BULB REPLACEMENT INSTRUCTIONS
3. Install the new bulbs in the same manner as old bulbs were removed. Re-install the diffuser (C).
Restore power to the fixture.
4. Dispose of the old bulb(s) in accordance with local, state, and/or federal laws.
ASSEMBLY INSTRUCTIONS
12. At the other end of the fixture, pull back on the end
cap (D) equipped with the spring (E) until that end of the
diffuser (C) clears. Raise the diffuser (C) into place until
the diffuser (C) seats and carefully release the end cap,
which will pivot back in place and securely hold the
diffuser (C).
Restore power to the fixture.
When bulb replacement is necessary, replace the bulb with a 32-watt, 120-volt/3,000K up to 4,100K/10,000
hour/F32T8 fluorescent bulb.
Before replacing the bulb, shut off power to the fixture at the circuit breaker or fuse panel. Allow
sufficient time for fixture and bulb to cool.
12
2. Remove the defective bulb by using thumbs to press
and roll the bulb 90 degrees inside the socket (B). This will
disengage the bulb contact pins from the socket (B)
contacts. Then slide the bulb pins out of the socket (B).
E
D
C
10
E
D
C
A
1. Remove diffuser (C) from fixture pan (A). One of the
end caps (D) is fitted with a spring (E) that allows the end
cap (D) to pivot away from the diffuser (C). Pull back on
the end cap (D) and gently pull the diffuser (C) out of the
end cap (D).
1
2
B
6
