5
598-1294-02
SPECIFICATIONS
Horizontal Range . . . . Up to 70 ft. (21 m); 100 ft.
(30.5 m) with Range Boost.
[varies with surrounding
temperature]
Vertical Range . . . . . . Up to 15 ft. (4.6 m)
Sensing Angle . . . . . . Up to 240° horizontal. Up to 80°
Vertical
Electrical Load . . . . . . Up to 200 Watt Maximum Tung-
sten Halogen [Up to 100 Watt
Maximum each bulb holder.]
Power Requirements . 120 VAC, 60 Hz
Operating Modes . . . . TEST, AUTO, and MANUAL
MODE
Time Delay . . . . . . . . 1, 5, 20 minutes
D
ual
B
rite
®
Timer . . . . 3, 6 hours, Dusk-to-Dawn
Replacement bulb . . . T4 100W, G8 halogen bi-pin 120
VAC
HeathCo LLC reserves the right to discontinue prod-
ucts and to change specifications at any time without
incurring any obligation to incorporate new features in
products previously sold.
POSSIBLE CAUSE
1. A bulb is positioned too close to the
sensor or pointed at nearby objects
that cause heat to trigger the sensor.
(Reposition the bulb away from the
sensor or nearby objects)
.
2. Sensor is pointed toward a heat source
like an air vent, dryer vent, or brightly-
painted heat-reflective surface.
(Repo-
sition sensor. Reduce RANGE)
.
3. Light control is in Manual Mode.
(Switch
to Auto)
.
1. Heat or light from the bulbs may be
turning the light control on and off.
(Reposition the bulbs away from the
sensor)
.
2. Heat being reflected from other objects
may be affecting the sensor.
(Reposi-
tion sensor)
.
3. Light control is in the TEST mode and
warming up.
(Flashing is normal under
these conditions. Turn BOOST off)
.
1. Sensor is detecting its own lights.
(Reposition bulbs to keep area below
the sensor relatively dark)
.
SYMPTOM
Lights stay
on continu-
ously.
Lights flash
on and off.
Lights flash
once, then
stay off in
Manual Mode.
SYMPTOM
Lights will
not come on.
Lights come
on in day-
light.
Lights come
on for no
apparent
reason.
Lights turn
off too late
in Dusk-to-
Dawn setting.
POSSIBLE CAUSE
1. Light switch is turned off.
2. Light is loose or burned out.
3. Fuse is blown or circuit breaker is
turned off.
4. Daylight turn-off is in effect
(Recheck
after dark)
.
5. Incorrect circuit wiring, if this is a new
installation.
6. Re-aim the sensor to cover desired
area.
1. Light control may be installed in a
relatively dark location.
2. Light control is in TEST.
(Set control
switch to an ON-TIME position)
.
1. Light control may be sensing small
animals or automobile traffic.
(Re-aim
sensor)
.
2. RANGE is set too high.
(Reduce
RANGE)
.
3. D
ual
B
rite
®
Timer is on.
1. Sensor is in a relatively dark location.
(Relocate sensor, or use 3 hr or 6 hr
setting)
.
TROUBLESHOOTING GUIDE
