Always unplug the heater before cleaning and allow the heater to cool down.
1. Clean the unit with a soft cloth moistened with a mild soap and water solution.
2. Never use abrasive or
fl
ammable solvents to clean the unit.
3. After cleaning, be sure to completely dry the unit with a cloth or towel.
4. Store heater unit with cord in a cool, dry location. We recommend storing the unit and
cord in the original package.
OPERATING INSTRUCTIONS
Thermostat Control
1. Before setting the thermostat, allow heater to operate and warm up the room. As noted
above, you need to turn the Thermostat Control clockwise to High to start the heater.
2. When the desired temperature comfort level is reached, lower the thermostat setting until
the heater stops operating. This is done by moving the Thermostat Control counter-clockwise
toward the Low setting
3. The control will now automatically maintain the pre-set temperature level by turning the
heater ON and OFF.
NOTE
: It is normal for the heater to cycle ON and OFF as it maintains the preset
temperature. To prevent the unit from cycling, you need to raise the thermostat setting.
CAUTION
: FRONT GRILL IS HOT WHEN UNIT IS IN OPERATION.
AUTO SAFETY SHUT-OFF WITH INSTANT
OVER HEAT PROTECTION
This heater is equipped with a technologically-advanced safety system that requires the user
to reset the heater if there is a potential overheat situation. When a potential overheat
temperature is reached, the system will automatically shut the heater off. It can only resume
operation when the user resets the unit. For specific reset instructions please refer to the unit.
RESET INSTRUCTIONS
If your heater shuts down:
1) Turn Control to OFF. 2) Unplug the unit and wait 30 minutes. 3) Plug in and operate normally
CARE AND MAINTENANCE
4
Tip Over Shut-Off:
When the unit is accidentally knocked over, it will instantly shut off. The unit may also
shut off if it is moved or bumped. To reset, simply place the heater in an upright position
and it will operate normally.
NOTE
: If unit does not turn on when placed in the upright position, turn the Mode Control to
High(
II
)setting and heater will resume operation.
