Safety Precautions
Figure 2 Attachment Locks in Unlocked Position
Installation of MTC Coring Attachment
To install the coring attachment:
CAUTION
1
1
Pins Unlocked
MTC Coring Unit. Operator’s Manual
© 2016 Utilicor Technologies Inc.
2
Until the attachment lock pins are fully in the locked position, the attachment has not
been safely secured to the machine. Do not stand near the attachment until it is fully
secured to the machine.
To release an attachment, rotate the attachment locks to the “unlocked” position (Item 1,
Figure 2). The lock pins will automatically rise, releasing the attachment from the machine. If
the pins do not release the attachment or are very hard to rotate, start the engine and tilt the
attachment slightly forwards or backwards until the pins can be rotated.
Position the attachment on a level surface.
NOTICE:
Clean the lower edge of the female attachment mounting plate to remove any
debris that might interfere with the attachment installation.
Start the machine engine, lower the loader arm and tilt the mounting plate forwards.
NOTICE:
Make sure that both of the attachment lock pins (Item 1, Figure 2 and Item 3,
Figure 3) are in the "unlocked" position.
Slowly drive towards the attachment and align the top edge of the male mounting plate
(Item 1, Figure 3) and the upper lip of the female attachment mounting plate (Item 2,
Figure 3).
NOTICE:
Make sure to position the attachments hydraulic hoses (Item 4, Figure 3) so that
they are not damaged during the installation process. Tuck the upper edge of the male
mounting plate into the upper lip of the female attachment mounting plate.
1.
2.
3.
