Chapter 5: Changing the Monitor’s Settings
UT100 Handheld Pulse Oximeter Operation Manual
5-1
Chapter 5: Changing the Monitor’s Settings
5.1 Changing the Pulse and Alarm Volume
Figure 5.1 Volume Bar
A “beep” tone sounds with each pulse beat. The volume of the “beep” can be
adjusted to seven
(7) settings.
Setting the volume by pressing the Up and
Down
Arrow, the volume is increased or decreased with each key press.
5.2 Managing the Patient’s Information
Please write down the information of the patient who is going to be
monitored like: Patient’s ID (from 000 to 999), Sex (Male or Female), Type
(Adult/
pediatric /neonatal) and Mode (Spot-Check/Record/Monitor).
Figure 5.2 Managing the patient’s information
1. Press the Menu key to enter into the Main Menu interface.
2. Press the Down key and the Menu key to enter the “Patient” submenu.
3. Press the Up/Down key to choose items you want to change and press the
Menu key to active the items.
4. Press the Up/Down key increase/decrease the setting and then use the
Menu key again to exit.
5. Press the Up/Down key to OK/ Cancel button to confirm/ cancel your
settings.
5.3 Changing the Alarm Limits
Summary of Contents for UT100
Page 2: ......
