Utax PF 730, Service Manual

Page: 49 / 118

3NJ-4
1-3-22
U034 5. Change the setting value using the +/- keys or numeric keys.
For output example 1, increase the value. For output example 2, decrease the value.
Figure 1-3-5
6. Press the start key. The value is set.
Caution
Check the copy image after the adjustment. If the image is still incorrect, perform the following
adjustments in maintenance mode for optimizing reading positions.
Table DP
Setting: [Mode]
1. Select On or Off.
2. Press the start key.
Setting: [Reset]
1. Select [Execute].
2. Press the start key.
Setting: [On Timing/ Off Timing]
1. Select the item.
2. Press the start key. The value is set.
Completion
Press the stop key. The screen for selecting a maintenance item No. is displayed.
Item No. Description
Center line of printing
(within ± 2.0 mm)
Correct image Output
example 1
Output
example 2
U034
U067 U072
Display Description
On Sets the conveying timing verification mode on.
Off Sets the conveying timing verification mode off.
Display Description
Value(Plain) Confirms the measured values of Plain.
Value(Thick) Confirms the measured values of Thick.