USR-W610 User Manual
Technical Support:
h.usriot.com
Jinan USR IOT Technology Limited
www.usriot.com
17
4.Parameter configuration
There are two ways to configure USR-W610. They are Web Server and AT command.
4.1.Web Server
User can connect PC to W610 through AP interface and enter Web Server to configure.
Web Server default parameters as follows:
Parameter
Default settings
SSID
USR-W610_xxxx(4 bytes MAC address)
Web Server IP address
10.10.100.254
Username
admin
Password
admin
Figure 21 Web server default parameters
After firstly connecting PC to W610, user can open browser and enter default IP 10.10.100.254 into address bar,
then log in username and password, user will enter Web Server.
4.2.AT command
We have specific user manual for AT commands.
4.2.1.Serial AT command mode
In work mode, user can enter AT command mode and send AT commands to module to configure the module.
For entering AT command mode, please refer to this FAQ:
http://www.usriot.com/enter-serial-command-mode/
.
4.2.2.Setup software
We also provide setup software for W610 which based on
serial AT commands
.
4.2.3.Network AT command mode
User can also use network AT command to configure W610. User can search W610 by sending UDP broadcast to
a fixed port and then send AT commands to configure W610.
