
USM Haller E
Operating Instructions
Date
02.19/us
12
13
3.1 Turning On / Turning Off /
Dimming
The e-Power supply has a foot switch (see
1.2 e-Power supply including e-Power cable) for
turning the power on and off. Press and hold the
same switch to dim the light.
Press briefly
Turns it on/off. When turned on, the most recently used
dimming setting is used.
Press and hold
Increases and reduces brightness. To change the
dimming settings, press the foot switch again and hold
until the desired brightness is reached.
3.2 Cleaning and Maintenance
Always unplug the furniture when cleaning.
Cleaning without water
Standard cleaning without water should be carried out with
a soft dust cloth*.
Cleaning with water
In the case of stubborn dirt, a cloth can be dampened with
water, wrung out and used to damp-clean the furniture.
A soft cloth* or chamois is suitable. If a cleaning agent is
necessary, use only a diluted neutral detergent (pH value <9).
Do not allow liquids to enter into the tubes, balls and
electrical components.
Attention: Never leave surfaces damp
or wet for long periods of time.
Never use abrasive cleaners or sponges.
Never use solvents.
3.3 Adapting the Product
Modifications to the USM Haller E shall be carried out
by USM or authorized USM personnel. The only aspects
that may be performed independently are replacing the
e-Inserts and installing the e-Reflective film, in accordance
with the following instructions.
3 Operation
3.3.1 Replacing the e-Inserts
See instruction A.
B.
3.3.2 Attaching the e-Reflective film
See instruction B.
In order to ensure that the warm white/cold white e-Lights
turn on and off reliably when the compartment is opened
and closed, a e-Reflective film must be installed on the door
according to the following instructions.
A.
1.
1. – 6.
7
4.
2.
5.
3.
6.
1.
4.
2.
5.
3.
6.
e
c
d
b
a
f
2mm
*We recommend the USM cloth