All rights are reserved by USI. No part of this technical document can be reproduced in any form
without permission of USI.
WM-BAC-AT-49 module, Wi-Fi/Bluetooth RF user manual, revision 1.0
Page 11
Peak gain
1.42 dBi @ 2.4 GHz
2.36 dBi @ 2.45 GHz
3.18 dBi @ 2.5 GHz
2.67 dBi @ 5.15GHz – 5.25GHz
2.27 dBi @ 5.25GHz – 5.35GHz
2.07 dBi @ 5.47GHz – 5.725GHz
1.78 dBi @ 5.725GHz – 5.85GHz
2.67
Bluetooth Antenna:
Antenna Type
Dipole
Antenna connector
IPEX
Peak gain
0.8 dBi @ 2.4 GHz
1.23 dBi @ 2.45 GHz
1.18 dBi @ 2.5 GHz
2.67
2.8
Label and compliance information
The final end product must be labeled in a visible area with the following: “Contains FCC ID:
COF-WMBACAT49”. The grantee's FCC ID can be used only when all FCC compliance
requirements are met.
2.9
Information on test modes and additional testing requirements
This transmitter is tested in a standalone mobile RF exposure condition and any co-located
or simultaneous transmission with other transmitter(s) or portable use will require a
separate class II permissive change re-evaluation or new certification.
2.10
Additional testing, Part 15 Subpart B disclaimer
:
This transmitter module is tested as a subsystem and its certification does not cover the
FCC Part 15 Subpart B (unintentional radiator) rule requirement applicable to the final host.
The final host will still need to be reassessed for compliance to this portion of rule
requirements if applicable.
As long as all
conditions above are met, further transmitter test will not be required. However,
the OEM integrator is still responsible for testing their end-product for any additional
compliance requirements required with this module installed
IMPORTANT NOTE:
In the event that these conditions can not be met (for example certain
laptop configurations or co-location with another transmitter), then the FCC authorization is no
longer considered valid and the FCC ID can not be used on the final product. In these
