8.
Activate the motor by pressing on the foot pedal switch and insert threading board
into rollers advancing film though both sets of rollers. (If film does not exit out
rear rollers or becomes wrapped around front rollers immediately stop motor
advancement by releasing pressure from the foot pedal switch, motor is reversible
by holding drive switch in the reverse position and depressing foot pedal).
9.
Install supplied feed table onto roll pins in front of the laminating rollers; edge
closest to rollers first, then press down.
10.
Switch drive switch to the forward position and depress the foot pedal, while
motor is running gradually tighten tension knobs to remove wrinkles from both
rolls of film as it enters the laminating rollers. Only apply enough tension as
needed, excessive tension can stall the machine, or cause accelerated wear on
motor and tension assemblies.
11.
Allow a few feet of film to advance to allow film to align.
12.
When inserting prints to be laminated use both hands to hold print taunt to prevent
wrinkles.
Page 5
