INSTALLATION
NOTE:
DO NOT discard
the carton or other packing
materials until you have
inspected the appliance for
hidden damage and tested it
for proper operation. Refer to:
SHIPPING DAMAGE CLAIM
PROCEDURE
on the inside of this
manual.
WARNING:
RISK OF PERSONAL INJURY
Installation procedures must be
performed by a qualified technician
with full knowledge of all applicable
electrical and plumbing codes.
Failure can result in personal injury
and property damage.
IMPORTANT:
Unit must remain in an upright
position during installation to
prevent damage to the
refrigeration system.
IMPORTANT:
Refrigeration system is air-cooled.
Recommended louvered grills or
equivalent openings front and rear,
each with a minimum size of twice
the surface area of the condenser,
to provide adequate air circulation.
IMPORTANT:
Access is required for the operation
of the drain valve and for
maintenance of the refrigeration unit.
Provide adequate access to the drain
valve and refrigeration unit.
IMPORTANT:
Unit flange must be sealed to the
countertop. Damage caused by leaks
due to improper installation is NOT
covered by warranty.
UNPACKING & INSPECTION
Carefully remove the appliance from the carton. Remove all
protective plastic film, packing materials and accessories from
the appliance before connecting electrical power or otherwise
performing any installation procedure.
Carefully read all instructions in this manual and the
Installation Instruction Sheet
packed with the appliance before
starting any installation.
Read and understand all labels and diagrams attached to the
appliance.
Carefully account for all components and accessories before
discarding packing materials. Store all accessories in a
convenient place for a later use.
COMPONENTS
2 ea. PAN RAIL, SIDE
2 ea. PAN RAIL, END
1-5 ea. PAN RAILS, INTERMEDIATE (qty differs w/ unit)
1ea.
BACKFLOW PREVENTER ASSEMBLY
1ea.
DRAIN VALVE
1ea.
DRAIN SCREEN
PREPARATION
Cutout dimensions for tank units and control panels are listed
on the
Installation Instructions
provided with the unit.
Countertop must be flat and level before the unit is installed.
After cutout is made, add stiffeners or bottom braces to
counter as required to support unit weight.
Provide louvered grills and service access below control panel.
After installation, apply a thin bead of food-grade silicone
sealant around the flange to seal it to the counter.
For installation in plastic counter tops, the counter material
must be protected from the heat of the warmer in order to
prevent discoloration and/or deterioration. The installer
should contact the manufacturer or distributor of the
countertop material for specific installation instructions.
Avoid storing flammable or combustible materials in, on or
near the appliance.
