![background image](http://html.mh-extra.com/html/usag/929-pc1-1-2/929-pc1-1-2_operation-manual-and-instructions_1063928012.webp)
12
LED LIGHT ACCESSORY
ATTENTION: LED light accessory must be charged before first use. LED light will not function until charged. LED light is shipped in
sleep mode, charging activates light function. (see charging section below)
Installation and Removal of LED Light
Removal:
To remove LED light accessory from tool, rotate the LED light acces-
sory counter clockwise, the LED light will make a ‘snap’ noise as it rotates. At
the top of the nose cone, the unlock symbol will line up with the hash mark when
fully unlocked. Pull the LED light accessory straight away from the tool to remove.
Charging port is located on the back side of LED light accessory (see charging
section below).
Install:
To install LED light accessory onto tool, line up the hash mark on top of
the nose cone with the unlock symbol. Place LED light accessory onto nose cone
toward back of tool until it stops. THEN rotate clockwise, the LED light accessory
will make a ‘snap’ noise as it rotates and locks in place. The hash mark on top of
the nose cone will now be lined up with the lock symbol.
Charging:
To charge the unit, connect the USB charging cable into the charging
port (A, Fig. 2) on the unit and then plug it in to an appropriate USB port. An AC
adaptor can also be used to charge the unit via a standard electrical outlet.
Longest life and best performance can be obtained if the battery pack is charged
when the air temperature is between 18° and 24 °C.
DO NOT charge the battery pack in an air temperature below +4.5 °C, or above
+40.5 °C. This is important and will prevent serious damage to the battery pack.
NOTE: While the unit is charging, the LED Light will blink continuously indicating
that the charging process has started. The completion of charge will be indicated
by the LED light remaining ON continuously in a dimmed state. The battery pack is
fully charged and may be used at this time or left in the charger. NOTE: To ensure
maximum performance and life of lithium-ion battery packs, charge the battery
pack fully before first use. The LED Light will fully recharge in 4 hours or less.
CAUTION: Do not stare into LED light. Serious eye injury could result.
There are two LED lights located around the square drive. The LED lights are
activated when the trigger switch is depressed.
- The LED lights will turn off after being illuminated for 20 seconds.
NOTE: The LED Lights are for lighting the immediate work surface and are not intended to be used as a flashlight.
PROPER HAND POSITION
Warning: To reduce the risk of serious personal injury, ALWAYS use proper hand position as shown.
Warning: To reduce the risk of serious personal injury, ALWAYS hold securely in anticipation of a
sudden reaction.
ADAPTOR STATUS INDICATOR
Fig. 2
A