USA Measurements US-PC-PH-15, User'S & Technical Manual

Page: 9 / 24

US-PC-PH & US-PC-PL .
7 .
( K X
) L Y
M Z
À Â Æ
Ç È É
Ê Ë Î
Ï Ô Ù
Û Ü
4. 4. 4. 4. OPERATIONS OPERATIONS OPERATIONS OPERATIONS
Normal Weighing Mode Normal Weighing Mode Normal Weighing Mode Normal Weighing Mode
1. Place the scale on a flat, stable surface. Level the scale using the leveling bubble at the lower left side of the display.
2. With the weighing platter empty, turn on power switch (located underneath on the right-hand side of the scale). Due
to the high resolution of this scale, allow 10 minutes for the scale to warm up before use for optimum results.
3. Press the ON/OFF key to power on the scale. The self-check will run and the scale will display a zero reading. The
scale is now ready for weighing.
Note: If the scale does not zero, an error code will be displayed. See Troubleshooting
Troubleshooting Troubleshooting Troubleshooting to resolve.
4. To change the weighing unit of measure, press the Unit key to toggle between kg, lb or oz.
5. Set the tare weight if desired.
6. Place objects on the scale platter and read the weight on the indicator.
7. When finished weighing, press the ON/OFF key for 4 seconds to power off the scale.
ZERO function
ZERO function ZERO function
ZERO function
1. Under the normal weighing mode, press Zero key to set the scale to zero point when the scale reading is stable
(the
weighing unit light without shining).
2. When under the tare mode, ZERO key is invalid.
Note: If the scale cannot be zeroed, an error code will be displayed. See Troubleshooting
Troubleshooting Troubleshooting Troubleshooting to resolve.
Setting the Tare Weight Setting the Tare Weight Setting the Tare Weight Setting the Tare Weight
This scale allows for both a manually entered pre-set tare weight, as well as a “weighed” tare weight.
1.
1. 1.
1. To enter a weighed tare:
To enter a weighed tare: To enter a weighed tare:
To enter a weighed tare: