6
Visit us online at www.USWaterSystems.com Give us a call at: 1-800-608-8792
Where To Install The Softener
Place the softener as close as possible to
the feed water source.
Place the softener as close as possible to
a drain pipe, or other acceptable drain
point.
Connect the softener to the main water
supply pipe BEFORE the water heater or
water storage tank.
DO NOT RUN HOT
WATER THROUGH THE SOFTENER
.
Temperature of water passing through the
softener must be less than 100 deg. F.
Outside faucets and irrigation systems
should be supplied with hard water prior to
the water softener. Soft water is not rec-
ommended for plants and grass.
Do not install the softener in a place where
it could freeze.
Damage caused by freez-
ing is not covered by the warranty.
Put the softener in a place water damage
is least likely to occur if a leak develops.
The manufacturer will not repair or pay for
water damage.
If installing in an outside location, you must
take the steps necessary to assure the sof-
tener, installation plumbing, wiring, etc. are
protected from the elements and contami-
nation sources.
Keep the softener out of direct sunlight
.
The sun’s heat may soften and distort
plastic parts.
Before Starting Installation
