Installation Instructions
Residential Reverse Osmosis Drinking Water System
Page 5
B. Mounting the faucet
1. Install the faucet as shown in Fig. 1 on the previous page.
Assistance may be needed to hold the faucet in place
while the nut is tightened. Install the finished washer on
the faucet.
2. Install the rubber washer on the faucet.
3. Install the plastic sleeve on the threaded rod.
4. Install the brass washer on the threaded rod.
5. Install the brass nut on the threaded rod.
6. Install the faucet in the sink and slide the plastic “U”
washer on the bottom of the sink on the faucet.
7. Tighten the nut on the faucet. Be sure the plastic sleeve is
in the correct position for the drain line barb connections.
The faucet should be held in the correct position when it is
tightened to the sink.