1. Familiarize yourself with the machine. Read all danger, warning, and caution statements and the Owner’s Manual before operating this
machine. If you or your operator cannot read English, have this manual explained fully before attempting to operate this machine.
2. Remove screw and abrasive retainer. Center abrasive on backing pad and secure with abrasive retainer and screw. Use provided wrench
to tighten paper screw (Figure
2)
Machine Setup
!
OPERATING INSTRUCTIONS
!
1. Move machine to the location of your work. Set any exposed nails with hammer and punch to avoid encounter with abrasive.
Bodily injury could occur if power is applied to the machine with the power switch already in the “ON” position. Always check to assure
that the power switch is in the “OFF” position before applying power to the power cable.
WARNING
2. Make sure the control switch is in the “Off’ position then connect the supply cable to an appropriately grounded fused circuit.
3. With the machine in the reclined position firmly grasp both handles and pull the control switch to the “ON” position.
4. Gradually lower pad to surface intended for sanding. Make sure the machine is in motion while the pad is engaged with the surface to be
sanded. You may use broad circular motion as you sand along the length of the surface or your may use a combination of forward and sideward
motions. In time you will develop your own technique to optimize coverage. It is advisable to not add effort to the pad as this may lead to “nosing
in” or “tipping” which produces grooves or lines on the surface.
5. When replacing abrasive or sanding operation is completed, return machine to reclined position, release the control switch to “Off” then
disconnect the motor pigtail from the supply cable.
DANGER:
Failure to disconnect the supply cable from machine whenever servicing, or replacing abrasive could result in electrocution or severe injury.
Never leave machine unattended while the supply cable is connected.
!
*Do not operate with belt guard removed. Serious injury may occur.
DANGER
!
Failure to perform maintenance at recommended intervals may void
the warranty.
CAUTION
ROUTINE MAINTENANCE
Carbon Brushes
Have the carbon brushes replaced at least every 500
hours and more frequently under heavy use.
Power switch
DREM18
V Belt
For 10” # 3L250
For 13” #
7” Flexible Backing Pad
DRE017
Set of brushes
DREM50
Bearing
DREM32
Pad axel
DREM03
5” Pulley and pad
with rubber
DRE015
Brush cap
DREM51
Handle Knob
DRE20
Power cord
DREM17
Motor pulley
DRE11
For more parts and information
call US Sander at 1866 USSANDR
1(866)-877-2637
Caster
DRE05
Motor
DRE50
Trigger Switch
DREM52
Variable Speed
Switch
DRE53
Side Handle
DREM54
Vacuum
Flange
DRE41
Drive Belt
For 10” 3L250
For 13” 3L310
Paper
wrench
DRE60
Paper Nut
DRE61
Paper Bolt
For 7 “ DRE63
For 5” DRE64
*Belt Cover
For 10” # DRE40-10
For 13” # DRE40-13
