US COOKING EQUIPMENT USSP-18-1, Operating Instructions Manual

Page: 13 / 26

- 12 -
Operating Instructions
Before operating, make sure to place the unit horizontally by adjusting bottom
adjustable legs, and place the catch tray properly.
The pilot light has been set at the factory. Each burner has a pilot light.
Lighting the pilot light
Turn the control valve at the position of “0” (Fig.2), make sure all knobs are in the close
state. Light and hold an ignition source at the pilots. The pilot light may not light
immediately, for existing gas in the pipe. Wait a minute, the pilot light will light after the
gas has extinguished. Tips: You can use a screwdriver to adjust the height of the flame
(Fig.3).
Igniting the main burner
R
evolve the main fire control valve knob anticlockwise after lighting the pilot light,
the main fire burner is lighted by the pilot light. The power of burner increases as the
revolving angel increases. When knob reaches to " ", burner is in the maximum
power (Fig.4).
Fig.2 Fig.3 Fig.4
ATSP-18-1 CONTROL PANEL ATSP-18-2 CONTROL PANEL
Burner outer ring Burner inner ring Front burner Front burner Back burner Back burner
control knob control knob outer ring inner ring outer ring inner ring
control knob control knob control knob control knob
Reminder: Turn on the knob controlling inner ring burner first, and then turn on the
main fire valve, as shown in Fig.5, and 6. Fig 5
Fig 6