URSUS TROTTER UT-KAFFEEDELUXE, Instruction Manual

Page: 10 / 16

4. Place an espresso cup you have prepared on
drip plate. Make sure the steam knob is at the “O”
position.
5. Note: As the appliance is not equipped with any
cup or jug, prepare your own jug or cup.
6. Connect into power source, press down the
ON/OFF button “ ” to turn on the unit. The power
indicator (red) will be illuminated.
7.
Press down the pump control button“ ”, the pump
will pump water, when there is water flowing out
and close the pump by pressing the pump control
button“ ” again.
8. Make sure the steam button “ ” is at the higher
position and wait for a moment, the appliance
begin preheating until the coffee indicator (green)
illuminates, it means that the preheating is finished.
9. Press down the pump control button“ ” again, and
water will flow out.
10.
After water has flown for 1 minute, press the pump
control button “ ”, you can pour out the water in each
container then clean them thoroughly, now you can
start brewing coffee.
Note: There may be noise when pumping the water
for the first time, it is normal, as the appliance is
releasing the air in the appliance. After about 20s,
the noise will disappear.
PREHEATING
To make a cup of good hot Espresso coffee, it is
recommended to preheat the appliance before
making coffee, including the funnel and cup, so that
the coffee flavour will not be influenced by the cold
parts.
1. Remove the removable water tank and fill it with
desired water, the water level should be between the
“MAX” mark and the “MIN” mark in the tank. Then
insert the tank into the appliance properly.
2. Set steel mesh into metal funnel (no coffee in steel
mesh), then put the metal funnel under the metal
funnel holder (see Fig.1), and turn it anticlockwise
until it is fixed tightly (see Fig.2 and Fig.3).
3. Place an espresso cup you have prepared on
removable cup shelf.
4. Then connect the appliance into power supply.
Make sure the steam knob is at the “O” position.
5. Press the ON/OFF button “ ” to turn on the unit,
the power indicator (red) will illuminate, make sure
the steam button “ ” is at the higher position.
6. Press down the pump control button“ ” to the
lower position, when there is water flowing out,
close the pump immediately by pressing the pump
control button“ ” again to the higher position. The
purpose of the step is to pump the water of the tank
into the housing.
7. When the coffee indicator (green) is illuminated,
and you should press down the pump control button
“ ” again, there will be hot water flowing out.
8. After water has flown for 20S, press the pump
control button“ ”. The preheating is finished.
MAKE ESPRESSO COFFEE
1. Remove the funnel by turning it clockwise.
2. Add ground coffee to steel mesh with measuring
spoon, a spoon ground coffee power can make about
a cup of top-grade coffee, then press the ground
coffee powder tightly with the tamper.
3. Set steel mesh into metal funnel , then put the
metal funnel under the metal funnel holder (see
Fig.1), and turn it anticlockwise until it is fixed tightly
(see Fig.2 and Fig.3).
4. Pour out the hot water in the cup. Then place the
hot cup (yourself cup) on removable cup shelf.
5. Make sure the steam knob is at the “O” position
and the steam button “ ” is at the higher position.
6. At the time, the coffee indicator (green) is
illuminated, once the lamp illuminates, you should
press down the pump control button“ ” to the lower
position, wait for a moment, there will be coffee
flowing out.
7. You should press and release the pump control
button “ ”to the higher position manually when
desired coffee is obtained or the color of coffee
changes weak obviously.
8. After finishing making coffee, press the ON/
OFF button “ ”, and the power indicator and coffee
indicator go out and the coffee maker stops working,
your coffee is ready now.
WARNING: do not leave the coffee maker unattended
during making coffee, as you need operate manually
sometimes!
Note: During brewing coffee or making steam, it is
normal that the ready indicator is likely to extinguish,
it only means that the heater is heating up to keep
the temperature at the standard range.
9. You can take the metal funnel out by turning
clockwise, then pour the coffee residue out with the
steel mesh pressed by press bar.
10. Let them cool down completely, then rinse under
running water.
MAKE CAPPUCCINO
You can get a cup of cappuccino by topping a cup of
espresso with frothing milk.