5
E N G L I S H
1. TECHNICAL DATA
Viewing Field: 90 x 40 mm.
Shade Control:
Light States DIN 4
Dark States DIN 9-13 Outside
adjustment.
Switching Time: Light - Dark 0.3.
Delay Time: Dark - Light 0.1 a 1.
Sensitivity & Delay Time:
Stepless adjustment.
UV/IR Protection:
Up to Shade DIN16.
Operating Temperature:
-5 Cº to + 55 Cº.
Power Supply: Solar cells assist, Inside
Lithium Batteries.
Lens Control:
Auto-on, Auto-off 15 minutes (when not
on welding).
Standards:
EN 379 EN 175 B EN 166 B
Helmet Material: PP (Fireproofing).
Total Weight: 480 grs.
2. ASSEMBLY INSTRUCTIONS
REPLACING THE PROTECTION LENS
1.
Ensure that the helmet is always fitted
with an outer and Inner protection
lens.
2.
These protection lenses must be
replaced if broken, damaged or
covered with welding spatter to the
extent that vision is impaired.
3.
Outer and Inner protection lenses are
consumables and must be replaced
regularly with genuine certified spare
parts..
HEADGEAR INSTALLATION
1. Install headgear by removing threaded
knobs (one at a time) and fasten again
after placing each threaded stud
through the larger holes on the sides
of the helmet.
2. Rotate the adjustment knob at the rear
of the headgear assembly to fit the
users head.
3. WORK AREA
•
Keep your work area clean and well lit.
•
Do not use electronic equipment in
explosive atmospheres, such as being
in the presence of flammable liquids,
gases or dust. Electrical products
generate sparks, which can cause fires.
4. TEAM USE AND CARE
•
Materials that may get in contact with
the wearers skin could cause Allergic
reactions to susceptible individuals.
•
Welding Helmets do not provide
unlimited eye, ear and face protection.
•
This Helmet is not suitable for laser
welding & Oxyacetylene.
•
Do not use this welding helmet while
working with or around explosive or
corrosive liquids.
•
Never place this Helmet and Auto-
Darkening filter on a hot surface.
•
Inspect the lens frequently. Immediately
replace any scratched, cracked, or
pitted cover lenses or auto-lenses.
