19
E N G L I S H •
User’s manual
The belt is too tightly or too loosely. Amend
the belt.
THE RUNNING DIRECTION OF MOTOR IS
NOT CORRECT
The wire connection of the motor is not cor-
rect. Change the way of wire connection.
AIR COMPRESSOR PUMP OR THE MOTOR
TEMPERATURE IS TOO HIGH
The working pressure is too high. Reduce the
using air pressure.
The air filter is blocked or the valves is block.
Cleaning the air filters.
The belt is too tightly or not balance. Amend
the belt.
The outdoor temperature is too high or not
good air ventilation is not good. Change the
palace.
The input power cable is too long or the volt-
age is too low. Change the power cable to use
standard.
THE AIR PRESSURE CAN NOT REACH TO
STANDARD PRESSURE
The valve is faulty. Change the valve.
Safety valve is air leakage. Inspect and repair.
Air compressor connection parts air leakage.
Inspect and repair with seal belt.
Pump pistons rings is broken. Change the new
pistons rings.
The belt is too loose. Check the belt and make
the belt is tighten.
THE NOISE IS TOO BIG
The pump lack of oil. Check the bear good or
not and fill new oil.
The belt guard is too loose. Switch off the ma-
chine and tighten the screw.
Piston heat the valve plates. Open the cylinder
head and inspect.
Pistons and valve plates have too much dust.
Open the cylinder and clean it.
The bearing is damaged. Change the bearings.
TOO MUCH VIBRATION
The belt is not balance. Inspect and balance
the two pulley.
The axle is out of shape. Sent to repair center
and change it.
The belt is too loose. Amend the belt.
The earth is not flat. Change the place.
THE AIR COME OUT FROM THE INLET
HALES (ON THE PUMP HEAD)
Air plate is broken. Change the valve plate.
The valve plate is wrong assembling. Change
the direction of the valve plate.
AIR COMPRESSOR DID NOT STOP
Air switch problem. Change the air switch, let
stop at 8 bar and restart at 5.5 bar.
Air requirements is too big. Use the heavy duty
air compressor.
OIL USING LEAKAGE
Compressor run in wrong direction, so pump
can not be cooled very well, so oil come out
from pump. Change to right direction.
Oil is too full. Check the oil level keep in the
middle of oil glass.
Piston rings or the cylinder broken. Inspect it
and repair them.
TECHNICAL DATA
COMP8100
COMP8200
VOLTAGE-FREQUENCY
TANK CAPACITY
OIL TANK CAPACITY
VOLUME AT 90 PSI
MAXIMUM PRESSURE
STAGES
POWER
WEIGHT
127 V ~ 60 Hz
100 L
1 L
5,46 CFM
8 bar (116 PSI)
1
2,5 HP
71 kg (156, 5 lb)
VOLTAGE-FREQUENCY
TANK CAPACITY
OIL TANK CAPACITY
VOLUME AT 90 PSI
MAXIMUM PRESSURE
STAGES
POWER
WEIGHT
127 V ~ 60 Hz
200 L
1 L
8,62 CFM
8 bar (116 PSI)
1
3 HP
101 kg (222,6 lb)
COMP8100-8200 manual.indd 19
30/11/15 5:12 p.m.
