Urrea CM1116, User Manual, Page: 14 / 20

14
TECHNICAL DATA
CM1116
VOLTAGE-FREQUENCY
220 V ~ 60 Hz
POWER 5 500 W
POWER CONSUMPTION 5,5 kWh
NO LOAD SPEED 3 450 r/min
WHEEL CAPACITY 16" (406,4 mm)
WHEEL CENTER 1" (25,4 mm)
WORK CYCLE 60 min x 20 min
WEIGHT 162 kg (357,1 lb)
MAX CUTTING:
· Round hollow bar
· Rectangle hollow bar
140 mm
90 mm x 120 mm
BEFORE INSTALLATION
• Determine where the sawing machine will be
placed. In doing so take into account the feed
and discharge of materials, optional built-on ac-
cessories, maintenance and repairs.
• Place the saw unit; if necessary by means of
hoisting equipment on the machine base (cover
at the rear) and attach each other.
• Secure the machine to the floor. The necessary
holes have already been made in the machine
base.
ELECTRIC DIAGRAM
Have the electrical connections made by a
qualified installer. Connect the machine in ac-
cordance with the electrical diagram applying
to your machine.
Check whether the direction of rotation of the
saw spindle corresponds to the arrow on the
safety guard. If the motor rotates in the wrong
direction, swtich two line wires.
OPERATION INSTRUCTIONS
BEFORE OPERATION
NOTE: before to start the motor verify the green
wiring connection to ground.
1. Make sure the power source is appropriate
for the tool.
WARNING: Never connect the power tool
unless the available AC power source is of the
same voltage as that specified on the nameplate
of the tool.
2. Make sure the trigger switch is turned OFF.
WARNING: If the power cord is connected to
the power source with the trigger switch turned
ON, the power tool will start suddenly and could
cause a serious accident.
3. Check the cut-off wheel for visible defects.
Confirm that the cut-off wheel is free of cracks
or other visible damages.
4. Confirm that the cut-off wheel is fixed secure-
ly to the power tool. Using the supplied hex. bar
wrench, tighten the clamping bolt on the cut-
off wheel mounting shaft to secure the cut-off
wheel.
WARNING: When the clamping bolt is loose,
the cut-off wheel may be damaged when the
wheel axle starts revolving, causing a hazardous
condition.
5. Use cut-off wheels whose peripheral speed
ratings are over the maximum working periph-
eral speed. When replacing the cut-off wheel,
ensure that the replacement cut-off wheel has a
designed peripheral speed.
6. Confirm the stopper position. Confirm that
the stopper which was used for installation and
removal of the cut-off wheel has returned to
the retract position.
1
7
3
2
4
5
6