26
−−−−
sec.3e
2 VOICE - Technical Manual
PUSH BUTTON PANEL
PUSH BUTTON PANEL SINTHESI STEEL
ASSOCIATION OF DOOR UNITS BUTTONS TO USERS
PUSH BUTTON PANEL SINTHESI STEEL
With door unit with the factory settings, the con
fi
guration
of column 0 is super
fl
uous because the buttons are all
assigned to that column.
SECONDARY DOOR UNITS
In door units con
fi
gured as secondary, buttons are associated by
default to the users from 0 to 63 of their column.
Col = X User = 2
Col = X User = 3
Col = X User = 0
1083/64
Col = X User = 1
Col = X User = 4
Col = X User = 5
Col = X User = 6
Col = X User = 7
Col = X User = 8
Col = X User = 9
Col = X User = 62
Col = X User = 63
If the door units are con
fi
gured as secondary, but each one must call
a different group of users, follow the instructions below:
Gain access to advanced con
fi
guration by rotating both the dip-
switches in position 9 (the yellow led turns on);
Set the call station ID dip-switch to the code of the apartment
station which will be associated to the
fi
rst button (offset);
The offset code must only be included between 0 and 31.
Change AUX dip switch n. 5 position (the door unit emits a
con
fi
rmation tone);
Put again the AUX dip switch n. 5 in its original position (the door
unit emits a con
fi
rmation tone);
•
•
•
•
AUX
Beep
Put again the ID dip-switches in their original position;
Quit the advanced con
fi
guration, by putting again the two rotary
switches in the positions used to set door lock release time and
guaranteed communication time: the yellow led switches off..
Example:
The secondary call station “A” calls only users from 0 to 10, the call
station “B” only users from 11 to 18.
1
2
3
4
LINE
LINE IN LINE OUT
IN1
IN0
Secondary call station
with 8 buttons
ID = n AUX dip2 = 1
offset = 11
it calls users
from 11 to 18
Secondary call station
with 11 buttons
ID = n AUX dip2 = 0
offset = 0
it calls users
from 0 to 10
2VOICE
power supply unit
Column
interface
ID = n
From street
side riser
On the call station “B”, gain access to advanced con
fi
guration;
Set ID dip-switch to 11
Move AUX dip switch n. 5
Put again all dip-switches in their original position;
Quit the advanced con
fi
guration
BUTTON CONFIGURATION FOR SPECIAL
FUNCTION
It is possible to con
fi
gure a button for a special function, for example
to turn the stairs lights on.
To con
fi
gure the button, perform as follows:
Go to advanced con
fi
guration.
Keep the selected button pressed for 3 seconds, the door unit
emits an acoustic signal to con
fi
rm that the acquisition has been
successfully performed.
The function can be activated only if a suitably programmed
special decoder is installed.
•
•
•
•
•
•
•
•
•
