14
DS4119-00
2.4.3 TEST ThE LOCATION
To test the location, plug the AC adapter into the repeater, then hold the repeater in the place where you
plan to mount it. The LED should remain on and steady, indicating that the repeater has a good signal from
the base.
2.4.4 INSTALLINg ThE REPEATER
Hold the repeater in its final location , and mark the center of the top edge.
From the edge mark, measure down approximately 4 cm, and mark the upper screw location, then
move down approximately 6 cm to mark the lower screw location.
At the screw locations, use a 4,8 mm drill bit to make two pilot holes approximately 2,5 cm deep.
Place the wall anchor into the pilot holes and tap it gently with a hammer until the anchor is flush with
the wall.
Insert the mounting screws into the anchor, leaving approximately 6 mm space between the screw head
and the wall.
Put the wall mount slot on the back of the repeater over the screw heads and slide the repeater down
into place.
IMPORTANT: Be sure the wall material can hold the weight of the repeater. Never install a repeater
in damaged or decaying wall material.
7. Connect the repeater to the corresponding power outlet.
Power socket
Wall mount slots
2.4.5 INSTALLATION OF TWO REPEATERS 4119/5 IN SEqUENCE
The two repeaters 4119/5 called A and B must be recorded near the base 4119/1.
Disconnect the power of both repeaters 4119/5 (A and B), take repeater A to the required position at a
distance of more than 10 metres from the fixed unit.
Power it and check activation: a BLUE steady LED will appear on the front panel.
The LED will remain RED to indicate that the connection is NOT active because the device is out of
range. In this case, position the repeater closer to the base of the 4119/1 telephone.
With repeater A powered and connected, take repeater B to the required position at distance of more
than 10 metres from repeater A, and power it.
Check activation: a BLUE steady LED will appear on the front panel.
The LED will remain RED to indicate that the connection is NOT active because the device is out of
range. In this case, position repeater B closer to the repeater A.
At this point, a call can be made using the cordless 4119/1 near repeater B and the call will be routed via
the two repeaters to the base 4119/1.
1.
.
3.
4.
5.
6.
1.
.
3.
4.
5.
6.
7.
