P18
DS1054-055A
1) Create the wireless bus
▶
Press the Connect
button
on module A once
(the LED on module A will start flashing),
then press the Connect
button on
module B once
(the connection between A and B is
established and the 2 modules stop flashing).
The two presses must occur within a
maximum time of 30 seconds.
▶
Repeat the same operation on modules B and C and so on, for all the others.
2) Pair the THERMARP thermostat with the module that controls the boiler
▶
After creating the wireless bus, temporarily move the thermostat to near the module
that controls the boiler. Pair the THERMARP thermostat with the module that controls
the boiler, following the steps described above
.
3) Set the access point on the wireless bus
▶
Place the thermostat in its final position.
▶
Return to the Wireless menu
of the THERMARP thermostat
.
▶
Use the buttons
and
to navigate the configuration menu to the
AP E7
“Bus
Access Point” submenu, then tap the “Confirm” icon
.
▶
Once the mode has been validated, the message
AP E7
starts flashing to confirm that the
THERMARP thermostat is in “Bus access point”
pairing mode. Press the “Connect” button of
the module closest to the THERMARP
thermostat once to establish the connection.
The PASS message appears briefly to confirm the connection.
Led
Connect
Led
Connect
Led
Connect
A
B
C
1 press
1 press
ETC
.
Led
Connect
