4
U S E R M A N U A L
URBANISTA LISBON
Thank you for choosing an Urbanista
product.
FIRST TIME PAIRING AND
RECONNECTING
To connect the earphones to a
Bluetooth device for the first time, open
the charging case whilst the earphones
remain inside the case. The earphones
will automatically enter pairing mode.
Open Bluetooth settings on your
device and select “Urbanista Lisbon”
to connect. If pairing is not established
within 5 minutes, pairing mode is
canceled and the procedure must start
over. The earphones will automatically
reconnect to the same device you have
paired them with when next turned on.
CONNECT TO ANOTHER DEVICE
Disconnect the earphones from the
device to enter pairing mode again or to
connect to another device. The earphones
can store up to six paired devices.
CHARGING AND BATTERY
The earphones will automatically
start charging when put back into the
charging case. A “low battery” voice
prompt will notify you when there are
30 minutes of playtime remaining, after
which the earphones will automatically
turn off.
Use the included USB Type-C cable
connected to a power source to charge the
case. The “Battery Status Indicator” (1) will
pulse during charging and continuously lit
when the case is fully charged.
• 0-35 % - The LED pulses red
• 35-70 % - The LED pulses white
• 70-100 % - The LED is lit white
continuously
When not charging the case, simply
open the lid to see the status of the
charging case battery.
GOFIT SILICONE WINGS
The included silicone wings can be used
for a secure fit.
RESET
1. Delete the “Urbanista Lisbon” from
the Bluetooth settings on your device.
2. Press and hold the “Reset Button” (2)
for 10 seconds, whilst the earphones
remain inside the case, until the
“Battery Status Indicator” (1) flashes
red quickly before turning white for
3 seconds. Close the charging case
to successfully complete the reset.
The reset can only be done while the
case is open.
3. Follow the instructions in “First
Time Pairing and Reconnecting” to
reconnect to your earphones.
( E N )
