Installing the Light Kit and Glass Shade
8.
Figure 15
LED light kit
Glass shade
Screws
Mounting
plate
Figure 14
Mounting
plate
Screws
Mounting ring
Wire connectors
CAUTION:
Before starting installation,
disconnect the power by turning off the circuit
breaker or removing the fuse at fuse box.
Turning power off using the fan switch is not
sufficient to prevent electric shock.
Step 1.
Remove 1 of 3 screws from the posts of
the mounting ring and keep it for future use.
Loosen the other 2 screws. (Do not remove)
Step 2.
Place the key holes in the mounting plate
over the two screws previously loosened from
the mounting ring. Turn the mounting plate until
the decorative cover locks in place at the narrow
section of the key holes. (Fig. 14)
Step 3.
Securely tighten the two mounting
screws previously loosened and the one
previously removed.
Step 4.
While holding the LED light kit under
the fan motor assembly, make the 2-pin wire
connections: (Fig. 15)
- White to white - Black to black
Step 5.
Remove 1 of 3 screws from the posts of
the mounting plate and keep it for future use.
Loosen the other 2 screws. (Do not remove)
Step 6.
Place the key holes in the LED light kit
over the two mounting screws previously
loosened from the mounting plate). Turn the
LED light kit until the light kit locks in place at
the narrow section of the key holes. Secure by
tightening the two light kit mounting screws
previously loosened and the one previously
removed. (Fig. 15)
Step 7.
Raise glass shade up against the light kit
and secure it to fan by turning glass clockwise
until snug. DO NOT OVERTIGHTEN.
