Section 2 - Service and Repair
Hydraulics
114101-000 X26 Ultra Narrow - Service Manual
Page 2-21
H
Y D R A U L I C
M
A N I F O L D
It is not necessary to remove the manifold to perform all maintenance procedures (i.e. replacing a single
valve). Determine whether or not the manifold should be removed before maintenance begins.
Refer to
Section 3 - Schematics
for the hydraulic schematic and hose routing diagram.
R
EMOVAL
AND
I
NSTALLATION
W A R N I N G
!
!
Before disconnecting the battery negative (–) lead, make sure all switches are OFF. If ON, a spark will
occur at the ground terminal which could cause an explosion if hydrogen gas or fuel vapors are
present.
Figure 2-15:
Hydraulic Manifold Location
1. Disconnect the battery
pack connector and the
battery negative lead.
2. Tag and disconnect the
solenoid valve leads.
3. Tag, disconnect, and plug
hydraulic hoses.
4. Remove the bolts that hold
the manifold to the mount-
ing bracket.
5. Remove the manifold
block.
Installation is reverse of
removal.
Torque mounting capscrews
to 11 N-m (
8 ft./lbs.
).
R
EPAIR
Refer to
Section 1 - General Information
for repair instructions.
Refer to Figure 2-16: “Hydraulic Manifold Exploded View,” on page 2-22.
