Upright SL-26, Service & Parts Manual

Page: 17 / 86

2-10
Towing or Winching
E
RECTION
P
ROCEDURE
Figure 5: Fold-down Guardrails
D A N G E R
! !
Before entering platform, guardrails must be securely fastened in their proper position.
2.7 T
OWING OR
W
INCHING
Perform the following only when the machine will not operate under its own power and it is
necessary to move the machine or when winching onto a transport vehicle (see “Transporting the
Work Platform” on page 13).
C A U T I O N
DO NOT tow or winch the machine faster than 0,3 m/s ( 1 ft./s ).
Faster speeds will damage drive components and void the warranty.
B
RAKE
R
ELEASE
P
UMP
Perform the following only when the machine will not operate under it’s own power and it is
necessary to move the machine or when towing the machine up a grade or onto a trailer to
transport.
Figure 6: Hydraulic Manifold
1. Raise side guardrails, making sure each is
pushed down to secure the guardrail in the
vertical position.
2. Install bolts, washers and nuts between the
side guardrails, tighten securely.
3. Raise rear guardrail assembly, aligning holes
and install bolts, washers and nuts. Tighten
securely.
Needle Valve
Hand Pump
1. Close the needle valve by turning the allen
screw clockwise.
2. Pump the Brake Release Pump until the
Parking Brake Cylinder Rod clears the
wheel rotor.
3. The machine will now roll when pushed or
pulled.
4. Be sure to open needle valve and verify
that the cylinder rod has extended before
the machine is operated.