06
48V100Ah - Energy Storage Lithium Battery Module - User Manual
2. Installation Tools
Attention before installation:
2.1
Insulation tools should be used to prevent short circuit during installation.
2.2
Power terminal installation must be checked for tightening, whether there is rust, corrosion or other foreign bodies,
if there should be wipe Clean, tighten the bolt, the battery bolt virtual connection will lead to the connection voltage
drop is too large, even when the current is large The heat burned the battery.
Following tools are required to install the battery module
NOTE:
Use properly insulated tools to prevent accidental electric shock or short circuits. If insulated tools are not
available, cover the entire exposed metal surfaces of the available tools, except their tips, with electrical tape.
When installing batteries, strictly follow the following steps. Do not change the installation sequence at will:
3.1
Before installing the battery, ensure that the battery is powered off or hibernated
，
If the battery is turned on or woke
up, press the "REST" button on the battery panel. Hold down the button for 3 seconds before releasing it. At this
time, the battery will enter the hibernation state, and the battery has no voltage output.
Electric Tools
Wire Cutter
Crimping Modular Plier
3. Installation Steps
Paseo de Extremadura, 39 - 28935 Móstoles - Madrid (Spain)
Tel. +34 918 021 649 - Fax. +34 917 750 542
www.masterbattery.es/en
