Uponor Smatrix Wave PLUS U@home R-167 – Smartphone/tablet apps l 39
The following points indicate how these results can be
interpreted:
• If all rooms have a low utilization degree (less than
30 – 40 %) the system supply is unnecessarily high.
• If all rooms have a high utilization degree (over 70 – 80 %),
the system supply is too low.
• If autobalancing is active, long loops will cause a higher
utilization factor. Please check your “Uponor Smatrix Wave
PLUS” manual.
• If the utilization factor is high but the room is cold, check
the actuator and the manifold valve for that zone.
Please contact your installer to check utilization factor results
and improve the energy efficiency of your installation.
Humidity Control
These features prevent condensation when in cooling mode
and adds the possibility of controlling a dehumidifier. Please
check the “Uponor Smatrix Wave PLUS” manual for more
information.
Minimum requirements to enable such functions are as
follows:
•
Cooling-enabled radiant system.
• A digital thermostat including humidity sensor, Uponor
Smatrix Wave PLUS Thermostat D+RH T-167, is needed in
the room you would like to control.
• The humidity control options can be accessed via the
“Room Settings” screen, but this applies only if cooling is
allowed for the room and fulfills the requirements stated
above. If you are unable to find this shortcut, please visit
the section “Basic use of U@home”.
From this page, the following parameters can be configured
and viewed:
• Current Relative Humidity (RH) value measured in the
room.
• Activation/deactivation of humidity control.
• By pressing the “RH options” you can set:
– Humidity setpoint.
– Humidity deadzone.
– Dehumidifier control: Yes/No
Please check the “Uponor Smatrix Wave PLUS” manual to
learn how these functions work.
The humidity control functions can be
reached from “Room settings”.
