4G PRIMARY
ALARM COMMUNICATOR
8
TESTING THE autoPRO UNIT
Prior to the initial powering of the unit, move the vehicle outside, so that the GPS
receiver can receive signals from the GPS satellites.
Upon initial power up of the UplinkGPS autoPRO unit, observe the LEDs located
on the front side of the unit to determine if the unit is powered on. If the LED is
not flashing, check the power connections. The status of the LEDs is below:
Status LED Definitions
MOde
state
OBd led
Cell led
GPs led
Initial Power
Up
GSM
Not
Applicable
Fast Blink –
On, 0.5 sec
Off, 0.5 sec
ON (Solid),
No GPS fix
Active,
NO GPS Fix
Ignition ON
Not
Applicable
Slow Blink –
On, 2.7 sec
OFF, 0.3sec
ON, Solid
Active,
with GPS Fix
Ignition ON
Not
Applicable
Slow Blink –
On, 2.7 sec
OFF, 0.3sec
ON, Blinking
(number of blinks
is the number of
satellites acquired)
Trip Upload
(immediately
after Ignition
is off)
Ignition OFF
Not
Applicable
Slow Blink –
On, 2.7 sec
OFF, 0.3sec
ON, Solid
(after 30 sec from
Ignition OFF)
Sleep
Ignition OFF
Not
Applicable
Slow Blink –
On, 2.7 sec
OFF, 0.3sec
ON, Solid
GPS VEHICLE
TRACKING SYSTEM
GPS VEHICLE
TRACKING SYSTEM
