Uplift Desk V2-Commercial, Manual

Page: 12 / 20

Step 15 - Keypad Attachment
There are two pairs of Keypad mounting holes pre-drilled into each
side of most UPLIFT desktops to accommodate several different
Keypad designs. Align the Keypad with the pre-drilled desktop
holes that best align with the Keypad’s mounting holes.
If you are using a desktop that does not include pre-drilled holes
for the Keypad (P6) attachment, locate the Keypad approximately
where shown in the image. Refer to Step 4 to make pre-drilled
holes for the Keypad attachment; be careful not to drill through
your desktop surface.
A.
Choose which side of the desktop you’d like your Keypad (P6)
to be located. Remember that you are assembling your desk
upside down, so the Keypad will be on the opposite side once
the desk is upright.
B. Align the Keypad with the pre-drilled desktop holes that best
align with the Keypad’s mounting holes.
C. Using a Phillips Head Screwdriver, attach the Keypad to the
desktop with two #10x5/8” Wood Screws (H14) . Be careful to not
overtighten to avoid stripping.
Top of desktop
Keypad left side
Keypad right side
Keypad right side
Keypad left side
Bottom of desktop
P6
H14
P6
H14
P6
H14 H14
P6
Step 14 - Caster Installation (optional)
If you purchased Casters for your desk, we recommend installing
them now.
A. First, remove the pre-installed Leveling Glides from the Feet by
rotating them counterclockwise to unthread them from the
mounting holes.
B. Install a Caster in each of the Leveling Glide holes by turning
the stem of the Caster clockwise, threading it into the hole. Use
a 12 mm or ½” flat wrench to tighten Casters that include a hex
nut on the threaded stem for tightening. Tighten firmly.