UPLIFT Desk
• 1-800-349-3839 • [email protected] • www.upliftdesk.com
Step 5
Be mindful of any wires hanging from your worksurface. Keep
them clear of the cross joints and tracks of the Main unit.
To gather several cables together, use the Velcro sheath.
Open it and run your cables through it, then close. This will
keep all cables together.
The Cable mounts can be placed on the back or under your
table to further secure your cables and keep them from mov
-
ing too much. Just make sure that there is enough slack in
the wires to allow the unit to raise and lower without pulling
your devices off the work surface.
Copyright Notice:
These instructions are a component of the UPLIFT Desk XF Standing Converter, medium. These instructions are part of the scope of delivery, even if the item is resold. These instructions
are also available on the UPLIFT Desk website: upliftdesk.com. Excerpts or copies may not be forwarded to third parties or used in any other published form without the prior written consent of UPLIFT Desk.
These instructions are subject to United States copyright law.
©
!
!
!
!
!
!
!
CAUTION:
Keep hands clear during operation! Do not reach into the mechanism near the
gas spring.
CAUTION:
Read all instructions before assembly. Failure to assemble properly may result
in damage or personal injury.
CAUTION:
The maximum load capacity of the unit is 33 lbs for the upper worksurface
and 4 lbs for the keyboard tray. Do not overload.
CAUTION:
Keep devices centered and away from the edge of the main worksurface, to
prevent them from falling.
CAUTION:
Make sure that the wires for your devices have enough slack. This will prevent
your devices from being pulled off the unit workstation when raising the unit.
CAUTION:
When moving, remove all devices to avoid harm or damage, and adjust the
unit to its lowest position.
CAUTION:
When moving the unit, move it carefully with two people, to avoid injury and
damage to the product and surroundings.
