© UPLIFT Desk
• 800-349-3839 • [email protected] • upliftdesk.com
Bolt-Through Method
Step 4 (Bolt-Through Method)
Ensure the desktop has a hole between 0.4’’ and 3.1’’
in diameter to use this option. Using a grommet hole
that is already in your desktop is acceptable, or you
can drill a 0.5” hole anywhere on your desktop.
Step 5 (Bolt-Through Method)
A. Use a small Phillips screwdriver to remove the oval
clamping plate from the top of the Bolt on the
Clamp Mount.
B. Remove the Bolt from the Clamp Mount.
Step 7 (Bolt-Through Method)
A. Slide the Bolt-Through Plate onto the Bolt from
Step 5 B.
B. Insert the Bolt through the hole in the desk from
below and align it with the threaded hole in the
bottom of the Bolt-Through Mount.
• Make sure the two set screw holes in the cylinder
of the Bolt-Through Mount are facing the back
of the desk and one of the three holes on the
flat part is pointing toward the front of the desk
so the Base Cover will be straight when it is at-
tached later.
C. Hand tighten the Bolt until the Bolt-Through Mount
is secure.
Step 6 (Bolt-Through Method)
Peel the adhesive backing off of the Adhesive Pad and
attach it to the bottom of the Bolt-Through Mount as
shown. Center the Pad within the circular edge of the
Bolt-Through Mount and press to adhere it.
0.4”
3.1”
