© UPLIFT Desk
• 1-800-349-3839 • [email protected] • www.upliftdesk.com
Adjustment Guide
Fluid Dimming Feature
Touch and hold the power button to dim the light to its dimmest setting.
To dim halfway, press and hold the power button and then release it when
it reaches the medium brightness you prefer. The Lamp will remember this
brightness after you turn the lamp off. Touching and holding the power
button again will bring the light back to its previous highest or lowest setting.
Lamp Rotation & Tilt
Lamp head will rotate right and left 200 degrees. Adjust the Lamp head’s tilt
by loosening the knob under the lamp head. Rotate to your preferred angle
and tighten the knob to set the lamp head in place.
Wide Range of Adjustabilty
The Lamp’s arm can rotate 150 degrees from the base and can be adjusted at
the joints to allow for several different Lamp positions.
150°
Copyright Notice:
These instructions are a component of the E7 LED Desk Lamp by UPLIFT Desk. These instructions are part of the scope of delivery, even if the item is resold. These instructions are also available on the UPLIFT Desk
website: upliftdesk.com. Excerpts or copies may not be forwarded to third parties or used in any other published form without the prior written consent of UPLIFT Desk. These instructions are subject to United States copyright law.
©
!
Caution:
Read all instructions before assembly. Failure to assemble properly may
result in product damage or injury.
!
!
!
!
!
Warning:
To avoid electric shock, do not disassemble or tamper with the Lamp or Power
adapter. Only use the Power adapter included with this Lamp.
Caution:
Do not use outdoors. Never use in a wet environment. Never allow liquid of any
kind to spill onto or enter any part of the product. Do not use in high temperatures.
Caution:
Route the power cord so it won’t be stepped on, pinched, or have items placed on it.
Do not place the Lamp anywhere where it could become a tripping hazard.
Warning:
When unplugging, do not pull on power cord or unplug from any angle other than
straight from outlet. Never touch metal conductors on the plug while plugging or unplugging.
Warning:
There is a pinch point in the space between the arm’s first segment and the
stabilizing metal bar. Keep fingers out of that space.
!
Caution:
Do not try to push the joints beyond their adjustment range, as this will cause damage.
!
Caution:
If using Lamp on an adjustable height work surface, raise to maximum height before
attaching Lamp to ensure that the power cord will reach the outlet when the worksurface is raised.
!
Warning:
Unplug and discontinue use in the event that the following occurs.
- The Power adapter or cord breaks
- The Lamp’s casing or one or more of the joints break
- The light emits sparks or smoke
- Abnormal flickering occurs or the LED bulb breaks
CAUTIONS & WARNINGS
!