© UPLIFT Desk
• 800-349-3839 • [email protected] • upliftdesk.com
Step 4
Note:
If you don’t want to install the Headrest, press
the Cover Plate (a) and Cover Cap (b) into place
where shown and proceed to the Adjustment Guide.
If you would like to install the Headrest, follow the
steps below:
A. The Headrest fits into the Back in a specific way.
Look for the lower holes on the rubber portion of
the Headrest (fig.01) and the recessed tab in the
Back (fig.02). These two parts fit together.
B. Angle the Headrest back, lining up the slots on the
Headrest with the tabs on the Back, and tilt the
Headrest forward firmly to fit the two parts to
-
gether.
C. Insert two M6x20 Screws and tighten using the Al-
len Wrench.
D. Lastly, place the two Plastic Caps over the Screws.
(a)
(b)
(fig. 01)
(fig. 02)
