© UPLIFT Desk
• 800-349-3839 • [email protected] • upliftdesk.com
Step 1
A. Be cautious around the small end of the Cylinder
to avoid getting grease on you or your clothes.
B. With the Base turned upside down, insert the
Caster stems into the holes on the Base and press
them firmly to secure them in place.
C. Flip the Base, so the Casters are on the floor, and
insert the Cylinder into the Base in the orientation
shown with the smaller diameter end up.
Step 3
A. Flip the chair assembly from Step 2 right-side up
and lower it onto the Cylinder.
B. Press down on the Seat (or sit on it) to secure it in
place on the Cylinder.
Step 2
Note:
The Screws and Washers may arrive inserted
into the Back. Simply remove them using the Allen
Wrench, and then use them to attach the Back to the
Seat following the steps below.
A. Place the Seat upside down on the edge of a sta-
ble surface, such as a table.
B. Insert the tab of the Seat into the slot on the Base
and line up the holes for the Back and the Seat.
Have a friend keep it steady while you attach the
Back to the Seat.
C. Using the Allen Wrench, attach the Back to the
Seat using three M8x20 Screws and three Flat
Washers. Start all Screws loosely, then tighten
them all using the Allen Wrench.
Vert Ergonomic Chair
SKU: CHR458
Allen Wrench
(L-shape)
Base
Casters
(qty 5)
Back
(with armrests)
M6x20 Screw
(qty 2)
Plastic Cap
(qty 2)
Cover Plate
(optional)
Cover Cap
(optional)
Note: may be pre-installed on Chair’s Back
Cylinder
Seat
Headrest
M8x20 Screw
(qty 3)
Flat Washer
(qty 3)
Package Contents
