Uovision um565-3g, User Manual

Page: 22 / 26

Page 20
Reasons for error:
1) The service in your area is not sufficient to run the camera.
2) There is an error when setting up the SIM card or it’s locked.
Suggestions to remedy:
1) Re
‐
do the UOV Set
‐
up to make 100% sure there aren’t any mistakes,
check to be sure the numbers and e ‐ mail addresses are correct.
2) Contact your network provider and make sure your SIM card is a Text
Feature Package only and is UNLOCKED.
3) If it’s a cellular service issue you may need to purchase a booster
antenna to help boost the signal. These can be very effective in boosting
the signal to your camera in a poor signal area.
“Network Busy:”
Reasons for error:
1) There is a problem with the phone number or email addresses.
2) There is not enough money on the SIM card plan.
Suggestions to remedy:
1) Re
‐ do the UOV setup. Make sure there are no mistakes.
2) Sometimes you need to go back to just one phone number or e ‐ mail
address at a time to find where the error is. Test with just one and if it
works, then add more and test.
3) Call in and re
‐ up your text plan with more texts.
Cannot access the SETUP menu:
Reasons for issue:
1) This only happens if you don’t have a SD card in the card slot or if the
SD card is corrupt.
2) Batteries are too low
Suggestions to remedy
1) Install a SD card or Install a new SD card
2) Replace the batteries.
14 Tricks and tips on field setup
For best results, mount the camera approximately 1.3m/4ft off the
ground facing straight forward as level as possible.
To enhance the flash, we recommend positioning the camera in an
area with a backdrop to reflect the maximum amount of light. For
instance, place the camera
7m-10m/20ft ‐ 30ft from a field edge facing
the woods. For the inside of timber, positioning the camera facing a