3
Transmitter and receiver channel syncronization
When synchronizing the units should not be more than one meter apart.
•
Press mute/sync button on transmitterr before it is turned on.
•
Turn the transmitter on and purple LED flashes to indicate the activation of channel-sync
mode.
•
Turn receiver(s) on to be channel synchronized (one or multiple receivers can be turned on at
the same time).
•
When channel is successfully synchronized, receiver’s LCD shows same channel as that of the
transmitter and its LED turns steady blue.
•
Press the transmitter’s mute/sync button to exit sync setup. When the transmitter has left sync
set up, the sound is turned off when the mute/sync button is pressed down.
Note! If synchronization fails
1. Turn the transmitter off and repeat above procedure to redo the synchronization.
2. If it still doesn’t work, turn off the transmitter and receiver(s) and redo the synchronzation
procedure again as described above.
Power / Signal indicator
Indicator behavior
Transmitter
Receiver
Flash
Red
Mute activated
Low battery
-
Blue
Mute activated
Sufficient battery
-
Purple
Sync activated
-
Steady
Red
Signal transmitted
Low battery
Signal received
Low battery
Blue
Signal transmitted
Sufficient battery
Signal received
Sufficient battery
No LED
Device is not turned on
Device is not turned on/
Signal is not received
Service and warranty
Product is covered by 2 years warranty. The product warranty doesn’t cover failure caused by
tampering, carelessness, improper handling or maintenance.
Under normal circumstances no special maintenance is required. In case of failure, if the product
should not work properly after the troubleshooting has been performed, please contact your local
distributor for further instructions.
Refer all servicing to qualified service personnel only. If the product is sent to Bo Edin AB, please
contact [email protected] and enclose a filled Service Form, www.univox.eu/support.
