MOUNTING THE VS9 TO POWER SOURCE EQUIPMENT
Again, before mounting the VS9, make sure that the power source equipment is turned off and its electrical supply disconnected or locked
out. Review the power take-off hub information in the manual for the power source equipment, then proceed as follows:
DIAGRAM 3
TYPICAL POWER TAKE-OFF HUB
Remove the chrome cover cap from the power take-off hub. Carefully lift the VS9 and insert the square milled shaft end into the hub intake
port (See diagram above), while holding the VS9 at the angle pictured below.
Slide the VS9 forward until the square milled shaft end firmly seats in the PTO adaptor [Diagram 3]. Gently twist the VS9 to a fully upright
position, slide locating pin [Figure 1(17)] into PTO locating hole and snug the thumb screw [Diagram 3 ]. NOTE: Only the #12 tapered hub is
fitted with a locating pin. the VS9 is now ready to process product.
DIAGRAM 4
MOUNTING ANGLE
(NOT OPERATING ANGLE)
PAGE 6
