FEET AND LEGS:
The different models covered by this manual use a variety of different feet and leg configurations, however
the removal and installation of the legs is essentially the same.
1. DISCONNECT THE ELECTRICAL POWER CORD.
2.
Remove the cover per Mechanics Maintenance removal of cover on page 1.2.
3. Remove the nuts or screws securing the feet or legs from the inside of the housing. The parts dia-
grams on the following pages should be helpful in removing and replacing the legs and feet on the
various models.
TUB CLIP:
Only the PM91 incorporates a tub clip on the front of the power unit. Removal of the tub clip is as follows:
1. DISCONNECT THE ELECTRICAL POWER CORD.
2.
Remove the cover per Mechanics Maintenance removal of cover on page 1.2.
3. Remove the screws securing the clip from the inside of the housing. The parts diagrams on the
following pages should be helpful in removing and replacing the tub clip.
Removal of front feet PM91
Removal of tub clip PM91
Page 5.1
Summary of Contents for MG8912
Page 13: ...PM91 ASSEMBLY FIGURE 2 8 1 2 3 4 6 5 9 10 7 11 12 13 21 18 17 20 14 15 16 17 19 Page 6 2 ...
Page 15: ...PM91G ASSEMBLY FIGURE 3 13 16 15 17 14 18 16 19 1 12 2 11 7 3 4 5 6 8 9 10 20 Page 6 4 ...
Page 17: ...MG8912 ASSEMBLY FIGURE 4 7 9 11 1 19 2 3 4 5 6 8 10 20 12 13 14 15 16 15 17 18 Page 6 6 ...
Page 19: ...VS2000 ASSEMBLY FIGURE 5 14 16 16 17 18 13 15 19 8 10 11 12 1 2 3 4 5 6 7 9 20 Page 6 8 ...
