Univex GL50, Parts And Maintenance Manual

Page: 6 / 29

TROUBLE POSSIBLE CAUSE REMEDY
1. MIXER WILL NOT
OPERATE 1.1 ELECTRICAL SERVICE DOWN. 1.1 CHECK ELECTRICAL SERVICE. REPLACE
FUSE
OR RESET CIRCUIT BREAKER AS
NECESSARY
1.2 SAFETY GUARD NOT CLOSED 1 .2 CLOSE SAFETY GUARD
1.3 TIMER NOT TURNED ON 1.3 TURN TIMER ON
1.4 EMERGENCY STOP BUTTON PUSHED 1 .4 TURN EMERGENCY STOP BUTTON
IN CLOCKWISE TO RELEASE
1.5 BURNED SWITCH CONTACTS 1 .5 REPLACE OR CLEAN CONTACTS
1.6 BURNED OUT MOTOR 1.6 REMOVE, TEST, REPAIR OR REPLACE
2. MIXER RUNS BUT
SPIRAL WILL NOT
TURN. 2.1 BROKEN OR SLIPPING BELT 2.1 TIGHTEN OR REPLACE
2.2 BROKEN PULLEY 2.2 REPLACE
3. SPIRAL RUNS BUT
BOWL WILL NOT RUN 3.1 BROKEN OR SLIPPING BOWL CHAIN 3.1 TIGHTEN OR REPLACE
4. ALL THE LIGHTS ARE
ON BUT MIXER WILL
NOT OPERATE 4.1 THE THERMAL PROBE STOPPED THE
MOTORS BECAUSE THE DOUGH WAS TOO
STIFF, OR THE MIXING TIME TOO LONG 4.1 WAIT 20 MINUTES UNTIL THE MOTORS
TEMPERATURE GOES DOWN AND PRESS
START BUTTON TO FINISH THE MIXING
CYCLE
5. EXCESSIVE NOISE 5.1 GEARS NEED TO BE REPACKED WITH
GREASE OR OIL LEVEL IS LOW. 5.2 NOTIFY A SERVICE AGENT
5.2 BADLY WORN OR FRYED DRIVE BELTS 5.2 REPLACE BELT
5.3 OVERLOAD MIXING BOWL. 5.3 ADJUST CONTENTS OF BOWL PER
MIXING CAPACITIES TABLE
TROUBLE SHOOTING GUIDE
6 of 2 9 GL50 MIXER