26
1
NOTE
: Ensure any existing remotes are present when
pairing to vehicle.
1. Close the vehicle doors.
2. Insert key into ignition and turn to
ON
(as far as you
can without cranking the engine).
3. Turn
ignition
OFF
and remove the key from the
ignition.
4. Press and hold the driver side door lock switch in
the
UNLOCK
position.
5. Insert and remove key from ignition 2 times
(do not turn the ignition key).
6. Insert the ignition key into the ignition
(do not turn the key) and leave key in ignition.
7. Release the door lock switch. The vehicle will sound
three beeps in order to verify the
PAIRING MODE
has been activated.
8. Press
the
LOCK
and
UNLOCK
buttons together
on the keyless entry remote and hold until the
vehicle beeps twice to verify paired (this takes
approximately 15 seconds).
9. Perform the previous step to pair up to four remotes
(including your old ones).
10. Remove the ignition key in order to exit the
PAIRING MODE.
11. Test all remotes.
2
3
NOTE
: Ensure any existing remotes are present when
pairing to vehicle.
1. Get into vehicle and close all doors.
NOTE
: Ensure any existing remotes are present when
pairing to vehicle.
1. Get into vehicle and close all doors.
2. Insert key into ignition.
3.
+ROGGRZQWKHSRZHU
UNLOCK
button on the
driver’s door panel - continue to hold down until
instructed to release in Step #9.
4. Perform Steps #5 through #8 in fairly rapid
succession.
5. Turn the ignition switch to the
ON
position
(as far as you can go without starting the engine).
6. Turn the ignition switch to the
OFF
position.
7. Turn the ignition switch to the
ON
position.
8. Turn the ignition switch to the
OFF
position.
9. Release the power
UNLOCK
button on the door
panel. The vehicle will
LOCK
and
UNLOCK
the
doors automatically.
NOTE:
These instructions were written by the vehicle manufacturer. They were designed to be easily performed
E\WKHFRQVXPHUWRDYRLGDWULSWRWKHGHDOHUVKLS:KLOHWKHLQVWUXFWLRQVDUHVWUDLJKWIRUZDUGVRPHPD\¿QGWKHP
challenging. With practice, you will succeed.
Many of the instructions have timing requirements. Waiting too long between steps may result in your vehicle’s
computer timing out, requiring you to start over. Once you begin the pairing procedure, be sure to move at a quick
and even pace.
2. Press and hold the
UNLOCK
button on door
ORFNVZLWFKRQGULYHU¶VGRRU+ROGXQWLOLQVWUXFWHG
to release.
3. Insert and remove key from ignition 2 times.
4. Insert key in ignition a third time and leave key in
ignition (do not turn the ignition key).
5. Release door lock switch on driver’s door panel. A
chime will sound 3 times indicating that you are in
PAIRING MODE.
6. Press both the
LOCK
and
UNLOCK
buttons on
the remote. Repeat this step if you are pairing
additional remotes.
7. Remove key from ignition to exit
PAIRING MODE
.
8. Test all remotes.
,PSRUWDQWUHDGWKLVÀUVW
PAIRING
