Page 17
M
X
-880Z
AND
M
RZ
-260 O
WNERS
M
ANUAL
Testing
Test a few commands for each device before fixing the flasher in place on
the front panel of a device.
Since TiVo, Replay TV, Satellite Receivers and Cable Boxes are all
extremely sensitive to IR overload or saturation, you should test them
thoroughly. Put up the on screen guide and test the navigation arrows.
Compare operation via RF to the original remote control. Operation
should be identical. Zigbee is not slower. If operation is inconsistent or
sluggish, lower the IR line output and/or reposition the flasher.
If you still have sluggish operation, check that the remote control is set to
a particular LINE OUT, rather than ALL. When IR commands are sent to
all the flashers in a cabinet, you can have difficulty adjusting the IR
Output. Reprogram the remote control to send IR commands only via a
specific (1-4) Line Output, then readjust the IR Line Output level.
1. Connect an IR emitter to each IR output and run the emitter wire to
the front panel of each component. DO NOT STICK the emitter in
place. ADJUST the level first.
2. Adjust each of the IR Output levels for best operation. If the compo-
nent operates best at minimum level, but is still operating sluggishly or
intermittently, move the emitter farther away from the components IR
sensor.
