![background image](http://html.mh-extra.com/html/universal-remote-control/star-light/star-light_operating-manual_1058818007.webp)
Programming the Remote,
(
Continued
)
7
C. Standard Set-Up:
Step
1
:
Turn on the device ( TV, VCR, Cable Box, Satellite Receiver, etc. ) that you
wish to operate.
Step
2
:
On the Star Light universal remote control, press the corresponding
DEVICE
button
(TV, VCR,CATV, SAT,Audio,or Aux)
and
the MUTE
button simultaneously.
Note: SET will appear in the LCD.
Step
3
:
Locate the three digit code number for your brand of equipment from the
code lists found on pp. (
15 31
). Example: TV codes-Sony
001,003
,etc.
Note: If the brand list contains more than one code number,
select the first code listed.
Step
4
:
Point the remote control at the devise turned on in Step
1
and press in the
three digit code number selected in Step
3
.
Note: SET # # # will appear in the LCD.
Your device will turn off when the correct code has been selected. If the
device fails to turn off, go back to Step
3
and select the next three digit
code for your equipment, and press in the code number.
Note: Repeat the above step until the device turns off. When
the device turns off proceed to Step
5
.
Step
5
:
Press the DEVICE button (TV, VCR, CATV, SAT, Audio, Aux) on the
remote control to store the three digit code that turned off your equipment.
Note: PASS will flash in the LCD indicating that the code has
been stored.
Step
6
:
Test the remote control functions with the code just stored.
Example: Power, Channel Up, Volume Up, etc. If any of the buttons do not
perform as they should, please repeat from Step
2
using the next three digit
code until the right code is found.
Step
7
:
To program other devices into the corresponding Device button of the
remote control, repeat the above steps with the respective devices and Device buttons.