![background image](http://html1.mh-extra.com/html/universal-remote-control/complete-control-mrx-1/complete-control-mrx-1_installation-manual_1058657024.webp)
Page 21
MRX-1 B
ASE
S
TATION
Frequently Asked Questions
Can I use flasher/emitters that I have already installed in the sys-
tem to connect to the MRX-1?
Yes, the flashers are compatible if they use 3.5mm mono mini plugs
with the same polarity (Tip is data, sleeve is ground). It is important
to notate the RFTX-1 shared port utilizes a sleeved emitter for long
term use.
I’m getting inconsistent operation regardless of flasher level or
position.
Some components are easily overloaded with IR from nearby flash-
ers. Prevent IR from affecting the problem component from other
flashers by setting the device to a specific IR Line Output instead of
ALL, then adjust the Line Output.
I am unable to control my URC Lighting Dimmer/Switch with the
MRX-1. Now what?
Make sure the RF switch on the RFTX-1 is set to the correct fre-
quency for the URC Dimmer or Switch. URC Lighting Models
MRFA is 418MHz and MRFB is 433MHz.
How do I update the firmware?
Make sure the MRX-1 is connected to the Network then open CCP
and click on the Firmware button located
How can I set my MRX-1 to factory default?
Look on the bottom of the MRX-1 and remove the cover plate to
reveal a reset button. Reboot the unit by pressing the reset button
once or press and hold for three seconds to factory default the unit.
Specifications
Network: One 10/100 Ethernet port
Relay: One relay configurable to be NO, NC or Momentary
Sensor: One sensor supports Video or Voltage sensing via URC sen-
sors.
RS-232: Two RS-232 ports support TX, RX and GND two way com-
munication via URC cables.
IR: Six adjustable IR ports enable the included URC emitters to
control IR devices Note: 6th IR Output requires the included
sleeved emitter (identified by a pink connector), since it can option-
ally be used to connect an RFTX-1
Weight: 8.4 oz.
Size: 248 x 120mm x28mm
Power: 12v External Power Supply