Universal Fibre Optics
5
CONNECTION
There are 3 connections required – the fibre port, the mains supply and the DMX interlink cable. The
fibre port should be connected first. Connect and secure the fibre optic connector into the front of the
unit and secure using the M5 locking screw.
Plug the mains plug into the electrical supply socket. Switch on power the led Indicator will illuminate
and the light source will start up automatically. If no light is produced consult the TROUBLESHOOTING
section.
NOTE: THESE LIGHT SOURCES ARE NOT MAINS DIMMABLE.
Now, connect up the RJ45 cable between the Master Light Source and the Slave or the Remote
Controller and the Slave, using the RJ45 sockets provided on the back of the light source – it doesn’t
matter which socket is used.
There are three modes of Slave operation – Standalone, Master/Slave and Remote DMX.
STANDALONE OPERATION
To use the Slave in manual standalone operation remove the DMX connector from the RJ45 socket at
the rear of the Slave and it will now respond to manual commands from the 2 control
buttons as detailed below.
OPERATION
The LED Light source has 2 colour cycles each with 3 different speed settings as detailed below:
Cycle
Colour 1
Colour 2
Colour 3
Colour 4
Colour 5
Colour 6
Colour 7
1
White
Red
Orange
Jade
Green
Cyan
Blue
2
Pink
Red
Orange
Jade
Green
Cyan
Blue
The Light Source is controlled using the 2 push buttons on the rear of the unit.
The Lower button STOPS and STARTS the colour Cycle
The Upper button is used to select the Cycle speed as follows. Push the Lower button repeatedly until
the colour White is displayed. The light source is now in Cycle 1 speed A as detailed below. Each push
reduces the speed. On the third push the colour Red will be displayed. The light source is now in Cycle 2
speed A.
Cycle
Speed A (fastest)
Speed B (slower)
Speed C (slowest)
1 (white start)
Push once
Push once
Push once
2 (red start)
Push once
Push once
Push once
At any time the cycle can be stopped on a colour and started again using the Lower push button.
