Universal Devices ISY-994i Series, User Manual

Page: 654 / 692

Page | 631
•
Use a sharp non-conductive object like a toothpick to press and hold in the Reset
Button.
•
Continue holding for approximately 4 seconds until all four (Rx, Tx, Mem, & Error)
lights blin k on/off in unison (Once per second).
•
Continue holding for approximately an additional 7 seconds until the same lights
turn on successively/consecutively (Rx, then Tx, then Mem, then Error) and then off
in the same order.
•
Release the Reset Button.
•
The Rx, Tx, Mem, Error lights will continue to turn on/off
sequentially/consecutively for a couple seconds.
•
Wait about one minute for the ISY to fully reboot.
•
Log in using the user name 'admin' and the password 'admin'.
23.13.3 ISY-99i Series
•
Use a sharp non-conductive object like a toothpick to press and hold in the Reset
Button.
•
Continue holding until all four (Rx, Tx, Mem, & Error) lights blink on/off in unison
(Once per second).
•
Continue holding for 5 seconds until the same lights turn on
successively/consecutively (Rx, then Tx, then Mem, then Error) and then off in the
same order.
•
Release the Reset Button.
•
Log in using the user name 'admin' and the password 'admin'.
23.13.4 ISY-26
Before you proceed with the procedure below, you will need to retrieve the MAC address of
your ISY device (see below)
To reset your userid and password please follow the steps as outlined below:
•
Disconnect PLM from the ISY.
•
Telnet to ISY
•
Enter MAC address as both the userid and password at login prompt
•
Wait 45 seconds (or until you see "Please connect PLM message")
•
Plug PLM back in
•
Log in again using admin/admin
Note: There is a time-out of 5 minutes for the PLM to get plugged back in. If timed out, the
userid and password are not reset.